TRANSFORMER :  
A double wound step up transformer is the most important part of the instrument. The Transformer is manufactured with high quality enameled/DCC Electrolytic copper wire/strip and CRGO core which offers very low no load losses.

INPUT VOLTAGE AVAILABLE : 415/230/110 Volts AC three/single phase50Hz. AC Supply

OUTPUT VOLTAGE RANGES : As per requirements 

CAPACITY : Up to 100KW

METERING :  
A moving coil type or digital volt meter and ampere met meter to indicate the charging voltage and current is provided on DC side.

TERMINATION : DC Positive and negative is brought on Bus Bars or Terminals, accordingly to the capacity of the unit. 

COOLING : Battery Charger are air cooled or oil cooled as per the capacity.

CONTROL : Knob to control the AC output from zero to maximum.

PROTECTION : 

• ON-OFF switch with fuse provided to protect the unit in case of short circuit. 

• HV will not actuate unless varies is at zero position.

• The HV trips off automatically if anybody tries to reach ball chain.

FAULT INDICATORS : Audio Alarm is provided to indicate fault which passes through ball chain.

FAULT COUNTER : An electro-magnetic counter is provided to count the faults with resetting knob.

ELECTRODE BOX : 

• Length-450mm or 600mm or 900mm

• Height Adjustable anywhere from 600-1000mm from ground level

OPTIONAL :

• Guide Rollers with strong frame.

• Tripping circuit to cut off the HT supply in case of faulty cable/bare conductor passing through electrode. 

• Sensitivity control 

• Sensitivity checking device.

• Stainless steel Electrode Box.